NOTES
1. TACHOMETER AND SPEEDOMETER SHAFTS.
Annually, disconnect shafts at both ends
(TM 9-2350-261-20), remove slotted wash-
ers from drive ends of cores, and remove
cores from instrument panel end of shafts.
Clean and lubricate cores with GIA. Insert
cores in shafts. Install slotted washers, and
connect both ends of shafts. If tachometer
adapter has a grease fitting, lubricate spar-
ingly with GIA.
2. OIL CAN POINTS. Every 1500 miles, semian-
nually, or as required, Lubricate ramp hinges;
ramp door hinges; power plant door hinges;
trim vane hinges and latches; driver's,
commander's and cargo hatch hinges; con-
trol linkage pins and shafts, and seat control.
Lubricate air box heater air motor. U s e
OE/HDO or OEA, as appropriate.
3. LUBRICATED AT TIME OF ASSEMBLY. Coat
ends of suspension torsion bar; idler wheel
support arm spindle and bearings; steering
control linkage bearing surfaces and pins;
and towing pintle shaft with GAA or GIA as
specified during assembly. Late model tow-
ing pintles do not have grease fittings and do
not require lubrication. Pack new support
arm and idler hub before assembly.
CARD 28 of 32
