| |
TM 9-2350-287-34
12-3. APU GEARCASE REPAIR (continued).
10.
Loosen six nuts (36) and washers (37), then turn and remove generator (15) from housing (27). Remove six
nuts (36) and washers (37). Discard nuts.
11.
Remove fitting assembly (30) and elbow (33) from hydraulic pump (32).
12.
Remove two screws (35) and lockwashers (34) and pump (32) from housing (27). Discard Iockwashers.
13.
Remove key (31) from pump (32) shaft.
14.
15.
16.
12-8
Remove four screws (41) and Iockwashers (40) from adapter (39). Discard Iockwashers.
Install two 3/8-16 screws in holes in adapter (39), and alternately tighten screws until adapter (39) is removed
from housing (27).
NOTE
Perform step 16 only if studs are damaged.
Remove any damaged studs (38) from housing (27).
|