| |
TM 9-2350-287-34
12-3. APU GEARCASE REPAIR (continued).
17.
Remove four screws (42) from bearing retainer (44).
18.
Install two 1/4-20 screws in bearing retainer (44), and alternately tighten screws until bearing retainer (44) is
removed from housing (27).
19.
Remove gasket (45) from housing (27). Discard gasket.
20.
Remove drive seal (43) and gear sprocket (24) from bearing retainer (44). Discard seal.
21.
Remove bearing (46) from gear sprocket (24).
22.
Remove bearing (47) from housing (27) bore.
23.
Repeat steps 17-22 for opposite side of housing (27).
12-9
|