| |
TM 9-2350-287-34
9-2. UPPER REAR DOOR SMALL DOORS AND HINGE REPLACEMENT (continued).
2.
Position upper rear door (2) on level surface capable of supporting the weight.
3.
Position two upper rear door small doors (11 and 14) as shown.
4.
Position two assembled hinge halves (3) on upper rear door (2) and two upper rear door small doors (11 and 14) as
shown.
WARNING
Unsafe welding practices can cause serious injury from fire, explosions, or harmful
agents. Allow only authorized personnel to weld metals, and follow precautions in
TC 9-237. Protective clothing and goggles must be worn, adequate protective
equipment used, a suitable fire extinguisher kept nearby, and requirements of TC 9-
237 strictly followed.
CAUTION
Be careful when welding near the edges of upper rear door and upper rear door small
doors. Do not weld into gaps between upper rear door and upper rear door small
doors. Failure to heed this caution can result in damage to upper rear door and
upper rear door small doors.
5.
Weld new assembled hinge halves (3) to upper rear door (2) and each of two upper rear door small doors (11 and 14)
with 1/8 inch of weld.
Change 1 9-4
|