TM 9-2350-287-20-1
2-19. TROUBLESHOOTING CHART (continued).
i.
NATO SLAVE RECEPTACLES
(1) NO POWER TO VEHICLE FROM NATO SLAVE
RECEPTACLE. Disabled vehicle had power when
operating.
Initial Setup:
Tools/Test Equipment:
l Disconnect slave cable from disabled vehicles
Digital multimeter (DMM) (Item 13, Appendix I)
slave start receptacle (refer to TM 9-2350-287-10).
General mechanics tool kit (Item 24,
l Disconnect batteries (para 7-41)
Appendix 1)
and leave disconnected for all steps.
Equipment Conditions:
. MASTER switch set to OFF (refer to TM
9-2350-287-1 0).
NOTE
l Instead of using multi meter
for voltage
check, STE/lCE
troubleshooting,
INDIVIDUAL
BATTERY VOLTAGE TEST-TEST
89 maybe performed.
l Instead of using multi meter
for continuity check, STE/lCE
troubleshooting, TEST 91 may
be performed.
A. 1. Disconnect wires 49A and 50A of wire
harness 12376573 at slave start receptacle.
2. Disconnect harness 12376573 from
drivers bulkhead.
3. Check continuity of harness 12376573 at
the following locations:
a. Pin B of bulkhead connector to wire 49A
slave receptacle connector.
b. Pin E of bulkhead connector to wire 50A
slave receptacle connector.
Is continuity indicated?
Repair wires 49A and/or 50A or replace
harness 12376573 (para 7-59). Verify
problem is solved.
Continued on next page
2-207