TM 9-2350-277-20-5
REPLACE COOLANT PUMP TO HEATER WIRING HARNESS Continued
0733 00
4.
Install circuit 402B lead (2) and screw (1) on terminal 4 (3) of terminal strip (4).
FOLLOW-THROUGH STEPS
1.
Install coolant heater and pump unit (WP 0728 00).
2.
Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).
3.
Start coolant heater (see your -10). Check that wiring harness is installed right. Turn heater off.
4.
Close power plant access door (see your -10).
5.
Raise trim vane (see your -10).
END OF TASK
0733 00-3/4 blank