TM 9-2350-277-20-3
REPLACE TOW START CONTROL ASSEMBLY AND BEARING Continued
0391 00
1.
Straighten out wire (1) or cut off wire to allow it to be removed. If too much wire is removed, discard cable assembly
after removal from bulkhead.
2.
Loosen front setscrew (2) that secures front collar (3) to end of cable assembly (4). Pull cable out of clevis pin (5) and
loosen rear setscrew (6) on rear collar (7). Remove front and rear collar from cable assembly.
3.
Remove cotter pin (8) and two washers (9) that secure clevis pin (5) to control lever (10). Remove clevis pin from
control lever. Discard cotter pin.
0391 00-2