7-22.4
Change 2
TM 9-2350-267-20
ACCELERATOR, THROTTLE AND ENGINE CONTROL GOVERNOR: REMOVAL AND INSTALLATION (CONTINUED)
TA57221
I
Remove spring pin (28) and lever (29). Use drive pin punch and
hammer to remove pin (28).
J
Remove three screws (30) and three lockwashers (31) at ac-
celerator shaft support bracket assembly (32). Discard
lockwashers.
K
Remove accelerator shaft support bracket assembly (32) from
bulkhead.
INSTALLATION
A
B
C
D
E
Install accelerator shaft support bracket assembly (32) on
bulkhead with three screws (30) and three new lockwashers(31).
Install lever (29) and spring pin (28).
Install bracket assembly (27) on hull bulkhead with three screws
(24), three new lockwashers (25) and three flat washers (26).
Install rod assembly (23) with two pins (22), two flat washers
(21) and two new cotter pins (20).
Install rod assembly (14) at bell crank (19) and bell crank (18)
with two pins (17), two flat washers (16) and two new cotter pins
(15).