ADJUST ACCELERATOR LINKAGE (M548A3) -- Continued
ADJUSTMENT FOR IDLE
Make sure all linkages are free moving and not binding. Make sure throttle pedal heel is
touching the floor plate.
With throttle control lever (1) at idle position and accelerator pedal against heel stop, adjust connecting link (2), and rod
end bearing (3) until screw (4) fits freely in throttle control lever (1) and rod end bearing.
Loosen jam nut (5) on connecting link (2).
Remove screw (4), washer (6), and lock nut (7) securing rod end bearing (3) to throttle control lever (1) on engine fuel
governor (8). Discard lock nut.