TM 9-2350-247-10
MAINTENANCE OF CAB COVER AND WINDOWS
0072 00
THIS WORK PACKAGE COVERS:
Removal of Cab Cover (page 0072 00-1).
Installation of Cab Cover (page 0072 00-2).
Escape Hatch Cover (page 0072 00-2).
Window Stowage (page 0072 00-3).
Remove/Install Windshield Sections (page 0072 00-3).
Remove/Install Cab Side Windows (page 0072 00-4).
INITIAL SETUP:
Maintenance Level
Operator
Personnel Required
Driver
Soldier
Equipment Condition
Engine stopped (WP 0023 00), (WP 0024 00)
Carrier blocked (WP 0038 00)
REMOVAL
1.
Loosen the tie down rope and unhook the rope from the cleats at the back of the cab.
2.
Unsnap the sides of the cab cover from the cab frame. (There are 12 snaps around each side window.)
3.
Pull the cab cover clear of the cab frame and slide the cover to one side. This will pull a rope bead at the front of the
cover out of a groove in the cover mount.
CAUTION
Take care not to damage the escape hatch ring or the plastic rear windows. Make sure the cover
is clean and dry. If you put it away wet or dirty, rot or mildew could ruin it.
4.
Fold and stow the cover.
0072 00-1