|
| |
TM 9-2350-287-34
4-3. UPPER FUEL TANK REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tool/Test Equipment:
Combination wrench, 1 1/4 inch (Item 8,
Appendix D)
l General mechanic’s tool kit (Item 19,
Appendix D)
Personnel Required: Three
Equipment Conditions:
Fuel system drained (refer to
TM 9-2350-287-10).
l Powerpack removed (refer to
TM 9-2350-287-20-1).
l Heat shield removed (refer to
TM 9-2350-287-20-1).
l Fuel level transmitters removed (refer to
TM 9-2350-287-20-1).
l Fuel hoses, tubes, and fittings disconnected
(refer to TM 9-2350-287-20-1 ).
a.
REMOVAL
WARNING
1.
2.
Do not smoke or use open flame when working on fuel systems. Fuel is highly
combustible and an explosion may occur, resulting in severe injury or death.
Loosen turnbuckle (1) on retaining strap (2).
NOTE
For correct installation, note number of washers removed at each strap location.
Remove two screws (6), four washers (4), and retaining strap (5) from upper fuel tank (3).
4-7
|
