|
| |
TM 9-2350-287-34
10-4.
PERSONNEL HEATER SUPPORT ASSEMBLIES AND RESILIENT MOUNTS
REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• General mechanic's tool kit
(Item 19, Appendix D)
Materials/Parts:
• Self-locking nut (4) (Item 119, Appendix H)
Personnel Required: Two
Equipment Conditions:
• Left and right projectile rack assemblies
moved to rear of vehicle (refer to
TM 9-2350-287-10).
• Numbers 1 and 2 engine AFES cylinder bottles
removed (refer to TM 9-2350-287-20-2).
• Numbers 1 and 2 engine AFES cylinder bottle
bracket straps, brackets, and mounts removed
(refer to TM 9-2350-287-20-2).
• Personnel heater removed (refer to
TM 9-2350-287-20-2).
• Personnel heater mounting clamps and
brackets removed (refer to TM 9-2350-287-20-2).
• PowerPack removed (refer to TM 9-2350-287-20-1).
• Engine compartment bulkhead insulation
and shields removed (para 9-3).
a.
1.
2.
3.
4.
b.
1.
2.
3.
4.
REMOVAL
Remove two screws (2) and washers (3) and upper supporl assembly (12) from forward bulkhead (6).
Remove two screws (4) and washers (5) and lower support assembly (7) from forward bulkhead (6).
Remove four screws (1), washers (11), and self-locking nuts (10), two angles (13), and two angles (9) from
upper and lower support assemblies (12 and 7).
Remove four resilient mounts (8) from upper and lower support assemblies (12 and 7).
INSTALLATION
Insert four resilient mounts (8) in upper and lower support assemblies (12 and 7).
Install two angles (9) and two angles (13) on upper and lower support assemblies (12 and 7) with four screws
(1), washers (11), and self-locking nuts (10).
Install lower support assembly (7) on forward bulkhead (6) with two screws (4) and washers (5), finger-tight.
Install upper support assembly (12) on forward bulkhead (6) with two screws (2) and washers (3), finger-tight.
10-16
|
