| |
TM 9-2350-287-34
10-2. BILGE PUMP REPAIR (continued).
4.
Inspect endbell (28) for cracks and warped mating surfaces. Replace if defective.
5.
Inspect seal cover (21) for cracks, warped mating surface, or other damage.
6.
Inspect four glass sleeves (27) for chips or breaks. Replace if defective.
Replace if defective.
7.
Connect red lead of multimeter to wire (37) and black lead to pin in connector (42) and check motor stator (36)
for continuity. If defective, replace bilge pump.
8.
Inspect key (29) for damage. Replace if defective.
c.
ASSEMBLY
NOTE
Perform step 1 only if bearing was defective.
1.
Install new bearing (40 or 41 ) in endbell (28 or 32).
10-5
|