|
| |
TM 9-2350-287-34
9-2. UPPER REAR DOOR SMALL DOORS AND HINGE REPLACEMENT (continued).
NOTE
Perform steps 9 through 13 only if threaded inserts were removed.
WARNING
Unsafe welding practices can cause serious injury from fire, explosions, or harmful agents. Allow
only authorized personnel to weld metals, and follow precautions in TC 9-237. Protective clothing and
goggles must be worn, adequate protective equipment used, a suitable fire extinguisher kept nearby, and
requirements of TC 9237 strictly followed.
Wear chip-guarding and personal protective equipment (goggles/shield, gloves, etc.) when using
grinder. Failure to follow this warning may result in severe injury to personnel.
9.
Inspect two threaded holes (16) in upper rear door small door (11 or 14). If threads in holes (16) are undamaged, go to
step 12. If threads in holes (16) are damaged, go to step 10.
10. Chip and fill-weld threaded holes (16). Grind weld until flush with surface of upper rear door small door (11 or 14).
Change 1 9-6
|
