|
| |
TM 9-2350-287-34
7-2. FINAL DRIVE ASSEMBLY REPAIR (continued).
11.
Remove eight screws (24) and Iockwashers (25), shaft seal (32), cap (26), gasket (27), and bearing (31) from
housing (5). Discard Iockwashers and gasket.
12.
Remove bearing (31), cap (26), and shaft seal (32) from output shaft (18). Discard seal.
13.
Remove two plugs (30) and screws (29) from housing (5).
14.
Remove three pins (28) from housing (5).
15.
Remove pin (33) from output shaft (18).
WARNING
Drycleaning solvent P-MO is toxic and flammable. Always wear protective goggles
and gloves, and use in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flames or excessive heat.
16.
7-4
|
