|
| |
TM 9-2350-287-20-2
15-2. AIR INTAKE GRILLE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Personnel Required: Two
Endless sling (Item 20, Appendix I)
Five-ton hoist (Item 23, Appendix I)
Equipment Conditions:
General mechanic's tool kit (Item 24,
Vehicle parked on level ground (refer to
Appendix I)
TM 9-2350-287-10).
Air intake grille opened and secured
Materials/Parts:
(refer to TM 9-2350-287-10).
Lockwasher (Item 164, Appendix H)
Self-locking nut (2) (Item 327, Appendix H)
a.
REMOVAL
1.
Install sling on handles (2) on
intake grille (1). Attach sling to
hoist, and take up slack.
2.
Remove screw (7), lockwasher
(6), washer (5), intake grille
support (3), and bearing (4)
from hull. Discard lockwasher.
3.
Remove quick-release pin (8)
from intake grille support (3).
4.
Remove four screws (12) and
exhaust
deflector
(14)
from
exhaust deck (13).
5.
Remove two screws (18) and
shield (17) from anchor (20).
6.
Remove
two
screws
(19),
washers (22), and self-locking
nuts (23) and anchor (20) from
right end cap (21).
7.
Using hoist, close intake grille
(1).
8.
Remove torsion bar (16) from
vehicle through right end cap
(21).
15-4
|
