|
| |
TM 9-2350-287-20-2
12-2. STEERING CONTROL LINKAGE REPLACEMENT (continued).
e.
1.
2.
3.
4.
5.
INSTALLATION
NOTE
• After installation is complete, final-tighten all mounting bracket screws at the same time.
• All washers and cotter pins used in the installation of rod ends may be installed after final
adjustment of steering controls.
If removed, install steering control lever (26) on transmission shaft with new retaining ring (25).
install rod (16), including dust boot (27) and clamp (28), through bulkhead and secure to steering control
lever (26) with quick-release pin (20).
Install housing bracket (24) on bulkhead with three screws (22) and new Iockwashers (23).
Install cover plate (17) on driver’s bulkhead with two screws (19) and new Iockwashers (18).
Connect rod (16) to lever (21) with quick-release pin (20).
12-10
|
