Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: 1. TRANSMISSION OIL FILTER.
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

—    K E Y    — Expected  Temperatures Lubricants Capacities Above  15°F +40°F to -10°F +40°F to -65°F Intervals (Above  -9°C)    (+4°C to -23°C)    (+4°C  to  -54°C) OE/HDO Intervals are as fol- (MIL-L-2104D) lows: LUBRICATING A - Annually OIL,   Internal OC - On Condition Combustion  En- Intervals are based on gine,  Tactical normal hours of op- Service eration and moderate operating  conditions. OEA MIL-L-46167) LUBRICATING OIL  Internal Combustion Engine, Arctic 48 qt OE/HDO OE/HDO Transmission (45.43 L) 15W40 15W40 OEA NOTES: 1. TRANSMISSION OIL FILTER. Remove three screws (2) and Iockwashers (3), cover, and filter element (1). Clean filter element with drycleaning solvent. Use compressed air to dry element. Inspect element for damage, and replace if  unserviceable. NOTE Where AOAP support is not available, drain and refill transmission after 75 hours of operation or 750 miles, whichever comes first. 2. TRANSMISSION DRAIN. After operation, park vehicle on level ground (refer to TM 9-2350-287-1 O). Remove three screws (8) and washers (9), cover plate (7), gasket (6), and drain plug (5) from bottom of hull. After oil has drained, clean drain plug (5) with drycleaning solvent and install plug (5), gasket (6), and cover plate (7) with three screws (8) and washers (9) on bottom of hull. Refill transmission with oil to within “Operating Range.” Check oil level before starting engine. Oil level indicator must be within “OPERATING RANGE” stamped on dipstick and filler cap (4). Add or drain oil (see key for required type) as required. Block vehicle tracks. With brakes applied and transmission in fourth gear, run engine at 1600-1900 rpm to warm the transmission oil. When transmission oil temperature gage reads over 180°F, run engine at 1200-1600 rpm for 1-3 minutes with transmission in neutral (N). After this period of time, oil temperature should stabilize between 180°F and 220°F. Stop engine, wait 3-5 minutes, then check oil level. NOTE When  operating  in  extremely  cold  temperatures  with  OEA,  this  is  a  semiannual check. G-3 TM  9-2350-287-20-2

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business