|
| |
APPENDIX G
LUBRICATION INSTRUCTIONS
This section lists all Unit maintenance lubrication instructions to be performed on the M992A1. Intervals (on-condition
or hard time) and the related man-hour times are based on normal operation. The man-hour time specified is the time
you need to do all the services prescribed for a particular interval. Decrease the intervals if your lubricants are
contaminated or if the equipment has been operating in adverse conditions, including longer than normal operating
hours. The intervals may be extended during periods of low activity. If intervals are extended, take adequate
preservation precautions.
For operator/crew Iubrication instructions, refer to TM 9-2350-287-10.
For lubrication instructions for hull-related components and conveyor, refer to TM 9-2350-287-10).
Dotted leader lines on an illustration indicate that lubrication is required on both sides of the equipment.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open frame or excessive heat.
The solvent’s flash point is 100°F-138°F (38°C-59°C).
Clean all fittings and areas around lubrication fittings with drycleaning solvent before lubricating components. After
lubrication, wipe off excess oil or grease to prevent accumulation of foreign matter.
G-1
TM 9-2350-287-20-2
|
