|
| |
B-3. EXPLANATION OF COLUMNS IN THE MAC. SECTION II (continued).
includes preparation time (including any necessary disassembly/assembly time), troubleshootin@fault
location time, and quality assurance/quality control time in addition to the time required to perform the
specific tasks identified for the maintenance functions authorized in the MAC, The symbol designations
for the variius maintenance levels areas follows:
c . . . ...** Operator or Crew
o . . . . . . . .
Unit
F . . . . . . . . . Direct Suppoti
H . . . ...*. General Support
D . . . . . . . . Depot (** in the column indicates that work
times are included in the depot maintenance
work requirement)
e. COLUMN 5, TOOLS AND EQUIPMENT. Column 5 specifies, by code, those common tool sets (not
individual tools), special tools (test, measurement, and diagnostic equipment), and support equipment
required to perform the designated maintenance function.
f. COLUMN 6, REMARKS. When applicable, this column contains a letter code, in alphabetic order, which
is keyed to remarks contained in Section IV.
B-4. EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS,
SECTION III.
a. COLUMN 1, TOOL OR TEST EQUIPMENT NUMBER REFERENCE CODE. This reference code
correlates with the code used in the MAC, Section II, Column 5.
b. COLUMN 2, MAINTENANCE CATEGORY. The symbol designation shown indicates the lowest level of
maintenance authorized to use the tool or test equipment.
c. COLUMN 3, ITEM NAME. This is the name or identification of the tool or test equipment.
d. COLUMN 4, NATIONAL STOCK NUMBER. This is the national stock number of the tool or test
equipment.
e. COLUMN 5, TOOL NUMBER. This is the manufacturer’s part number.
B-3
|
