|
| |
TM 8-2350-287-20-2
18-15. APU PANEL SUPPORTS REPLACEMENT.
This Task Covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
Initial Setup:
Tools/Test Equipment:
• Rubber adhesive (Item 4, Appendix D)
• General mechanic’s tool kit (Item 24,
• Lockwasher (6) (Item 196, Appendix H)
Appendix I)
Equipment Conditions:
Materials/Parts:
• Vehicle parked on level ground (refer to
• Dry cleaning solvent (Item 27, Appendix D)
TM 9-2350-287-10).
• Rag (Item 56, Appendix D)
• APU panels removed (para 18-14).
a.
1.
2.
3.
b.
1.
2.
REMOVAL
Remove two screws (5), Iockwashers (6), and washers (7) and support (8) from hull. Discard Iockwashers.
Remove two screws (14), Iockwashers (13), and washers (12) and support (11) from hull. Discard
Iockwashers.
Remove two screws (1), Iockwashers (2), and washers (3) and support (4) from hull. Discard Iockwashers.
DISASSEMBLY
Remove three hook-and-pile tape sections (9) from three supports (4, 8, and 11), and remove hook-and-pile
tape section (10) from hull.
WARNING
Drycleaning solvent (P-D-680) is toxic and flammable. Always wear protective goggles
and gloves, and use only in well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat,
Thoroughly clean surfaces of three supports (4, 8, and 11) and hull surfaces with drycleaning solvent and
clean, dry rags.
WARNING
Adhesives can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in well-ventilated
area. If adhesive gets on skin or clothing, wash immediately with soap and water.
18-40
|
