|
| |
TM 9-2350-287-20-2
17-34. CONVEYOR HYDRAULIC HOSES AND FlTTINGS REPLACEMENT (continued).
5.
Position two grommets (15) and plates (18) where
hose two assemblies (1) pass through crew
compartment floor.
6.
Secure two plates (18) with four new Iockwashers
(17) and screws (16).
7.
install two hose assemblies (1) in two straps (5)
and secure with two new Iockwashers (7), washers
(6), and screws (8).
8.
Position plate (11 ) and two grommets (4) where
hose assemblies pass through crew compartment
floor.
9.
Secure plate (11 ) with two new Iockwashers (1 O)
and screws (9).
10.
Connect two hose assemblies (1) to two tubes (2)
at hydraulic control panel (3).
FOLLOW-ON MAINTENANCE:
•Operate APU and check hydraulic system for leaks (refer to TM 9-2350-287-10).
• Start conveyor and check for leaks (refer to TM 9-2350-287-10).
• Install left rear fatigue mat (refer to TM 9-2350-287-10).
• Stow conveyor (refer to TM 9-2350-287-10).
• Close upper and lower rear doors (refer to TM 9-2350-287-10).
17-122
|
