|
| |
TM 9-2350-287-20-2
17-14. DRIVE-END SECTION COUPLING SPROCKET, PILLOW BLOCKS, AND DRIVE
SPROCKET ASSEMBLY REPLACEMENT (continued).
NOTE
Do not drive shaft completely through second pillow block.
4.
Drive shaft (15) partly through second of two pillow blocks (8).
5.
Install key (14) in keyway of sprocket assembly (6).
6.
Position sprocket assembly (6) to receive shaft (15), and drive shaft (15) through sprocket assembly (6).
NOTE
Make sure sprocket (26) is alined with center of conveyor drive-end section (2)
7.
Install two setscrews (12). Do not tighten setscrews (12).
8.
Tighten two setscrews (7) and setscrews (9) in two pillow blocks (8), setscrew (16) in sprocket assembly (6),
and two set screws (12) in sprocket assembly (11).
17-34
|
