| |
TM 9-2350-287-20-2
17-8. DEAD-END SECTION ASSEMBLY REPAIR (continued).
11.
12.
13.
14.
15.
NOTE
Steps 11 through 15 apply only to rear dead-
end section assembly.
Install deadman switch (12) in rear dead-end
section assembly (1) with four washers (24),
Iockwasher (23), key washer (22), and two nuts
(21).
NOTE
Perform step 12 only if wear strip was removed.
Install wear strip (16) on moving bracket (18) with
four screws (17).
Install moving bracket (18) over deadman switch
(12) on rear dead-end section assembly (1) with
four screws (25).
Install override safety switch (11) on rear dead-
end section assembly (1) with two new Iockwashers
(26) and screws (27).
Install two wear strips (19 and 20) on rear dead-
end section assembly (1) with four screws (15).
17-18
|