|
| |
TM 9-2350-287-20-2
17-6. CONVEYOR ASSEMBLY AND SUPPORT STAND REPLACEMENT (continued).
7.
8.
9.
b.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove four screws (12) and Iockwashers
(13) and support stand (10) from vehicle floor.
Discard Iockwashers.
Loosen nut (14) and remove support stand
stop (15) from support stand (10).
Loosen two set screws (11) and remove vertical
support (9) from support stand (10).
INSTALLATION
Install vertical support (9) on support stand
(10) and secure with two setscrews (11).
Install support stand stop (15) on support
stand (10) and tighten nut (14).
Install support stand (10) on vehicle floor with
four new Iockwashers (13) and screws (12).
Install sling to conveyor assembly (3) and
hoist.
Using hoist, install conveyor assembly (3) on
vertical support (9).
Connect two support slings (4) to conveyor
assembly (3) with two quick-disconnect pins
(5).
Install pin (8) and two washers (7) and new
cotter pins (6) in vertical support (9).
Remove hoist and sling from conveyor
assembly (3).
Connect two hydraulic hoses (2) to conveyor
motor (1).
FOLLOW-ON MAINTENANCE:
l Install conveyor wiring harness (para 7-70).
l Install conveyor supports (para 17-4).
l Install conveyor springs (para 17-7).
l Open hydraulic ball valve (refer to TM 9-2350-287-10).
17-10
|
