|
| |
TM 9-2350-287-20-2
17-6. CONVEYOR ASSEMBLY AND SUPPORT STAND REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
Drain pan (Item 14, Appendix I)
Vehicle parked on level ground (refer to
Endless sling (Item 20, Appendix I)
TM 9-2350-287-10).
Five-ton hoist (Item 23, Appendix I)
Hydraulic ball valve closed (refer to
General mechanic's tool kit (Item 24,
TM 9-2350-287-10).
Appendix I)
Hydraulic system pressure relieved to 0 psi
(refer to TM 9-2350-287-10).
Materials/Parts:
Conveyor springs removed (para 17-7).
Cotter pin (2) (Item 28, Appendix H)
Conveyor supports removed (p ara 17-4).
Lockwasher (4) (Item 168, Appendix H)
Conveyor wiring harness removed
(para 7-70).
Personnel Required: Two
a.
REMOVAL
WARNING
·Make sure conveyor is supported
before removal. Conveyor can fall,
causing severe injury or death to
personnel.
·Be
careful
when
deploying
conveyor
without
springs
attached.
Deploy
slowly.
Conveyor may move faster than
anticipated, causing severe injury
to personnel.
NOTE
To aid in installation, tag hydraulic
hoses when removed.
1.
Place drain pan un der conveyor motor (1).
2.
Disconnect two hydraulic hoses (2) from
conveyor motor (1).
Change 1 17-8
|
