| |
TM 9-2350-287-20-2
16-9.
PERSONNEL HEATER MOUNTING CLAMPS AND BRACKETS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
l Numbers 1 and 2 engine AFES cylinder
l General mechanic's tool kit (Item 24,
bottles removed (para 21 -4).
Appendix I)
l Numbers 1 and 2 engine AFES cylinder
l Socket wrench set 3/8-inch drive
bottle bracket straps, brackets, and
(Item 57, Appendix I)
mounts removed (para 21 -8).
l Personnel heater removed (para 16-7).
Materials/Parts:
l Cotter pin (4) (Item 11, Appendix H))
Equipment Conditions:
l Left and right projectile rack assemblies moved
to rear of vehicle (refer to TM 9-2350-287-10).
a.
1.
2.
3.
4.
b.
1.
2.
3.
4.
REMOVAL
Remove two cotter pins (3), washers (4), straight pins (5), and upper clamp halves (8) from upper saddle
bracket (2). Discard cotter pins.
Remove two cotter pins (9), washers (10), straight pins (12), and lower clamp halves (13) from lower saddle
bracket (11 ). Discard cotter pins.
Remove two screws (7) and washers (6) and upper saddle bracket (2) from forward bulkhead (16) and two
angles (1).
Remove two screws (14) and washers (15) and Iowersaddle bracket (11) from forward bulkhead (16) and two
angles (17).
INSTALLATION
Install lower saddle bracket (11) on two angles (17) and against forward bulkhead (16) with two screws (14)
and washers (15).
Install upper saddle bracket (2) on two angles (1) and against forward bulkhead (16) with two screws (7) and
washers (6).
Install lower clamp halves (13) in lower saddle bracket (11) with two straight pins (12), washers (10), and new
cotter pins (9).
Install upper clamp halves (8) in upper saddle bracket (2) with two straight pins (5), washers (4), and new cotter
pins (3).
16-20
|