|
| |
TM 9-2350-287-20-2
a.
REMOVAL
1.
Remove bolt (2) from roadwheel arm (1).
2.
Insert plug wrench (5) in retainer (4) and turn
counterclockwke.
Make sure all personnel keep hands away
from roadwheel arm and track. Failure to
comply with this warning may result in
serious injury to personnel.
3.
Place hydraulic jack under roadwheel hub end of
roadwheel arm (1).
4.
Remove retainer (4) and gasket (3) from end of
torsion bar (6). Discard gasket.
5.
Install mechanical puller adapter (7) and slide
hammer-type puller (8) on torsion bar (6).
NOTE
If torsion bar is broken and other end of torsion
bar cannot be reached for removal, it maybe
necessary to remove torsion bar anchors of
corresponding torsion bar (para 11 -3).
6.
Remove torsion bar (6) through roadwheel arm (1).
11-2
WARNING
|
