|
| |
TM 9-2350-287-20-2
15-62. DRIVER’S SEAT REPAIR.
This Task Covers:
a. Removal
b. Disassembly
c. Cleaning and Inspection
d. Assembly
e. Installation
Initial Setup:
Tools/Test Equipment:
• General mechanic’s tool kit (Item 24,
Appendix I)
Materials/Parts:
• Drycleaning solvent (Item 28, Appendix D)
• Rag (Item 56, Appendix D)
• Sealing compound (Item 58, Appendix D)
• Cotter pin (Item 10, Appendix H)
• Cotter pin (Item 22, Appendix H)
• Self-locking nut (Item 328, Appendix H)
• Self-locking nut (2) (Item 330, Appendix H)
• Self-locking nut (Item 331, Appendix H)
• Self-locking nut (Item 333, Appendix H)
• Self-locking nut (4) (Item 334, Appendix H)
• Self-locking nut (4) (Item 385, Appendix H)
Personnel Required: Two
Equipment Conditions:
• Vehicle parked on level ground (refer to
TM 9-2350-287-10).
• Driver’s hatch opened and secured
(refer to TM 9-2350-287-10).
a.
REMOVAL
1.
Remove two screws (6) and driver’s seat stops (7 and 17) from vertical support (5).
2.
•
•
WARNING
Driver’s seat assembly is spring loaded. To prevent injury, DO NOT raise adjusting
lever without holding seat.
Driver’s seat assembly is heavy. To prevent injury when lifting seat assembly, two
persons are required.
Raise adjusting lever (12) and remove driver’s seat assembly
(3) and driver’s seat support (11) from vertical support (5).
15-149
|
