|
| |
TM 9-2350-287-20-2
15-46. COMMANDER’S CUPOLA BODY REPAIR.
This Task Covers:
a. Removal
b. Cleaning and Inspection
c. Installation
d. Adjustment
Initial Setup:
Tools/Test Equipment:
• General mechanic’s tool kit
(Item 24, Appendix I)
Materials/Parts:
• Adhesive, rubber (Item 5, Appendix D)
• Drycleaning solvent (Item 28, Appendix D)
• Rag (Item 56, Appendix D)
• Cotter pin (2) (Item 16, Appendix H)
• Cotter pin (2) (Item 17, Appendix H)
• Cotter pin (2) (Item 18, Appendix H)
• Cotter pin (Item 24, Appendix H)
• Gasket (Item 71, Appendix H)
• Seal (Item 261, Appendix H)
• Spring tension washer (Item 370, Appendix H)
Equipment Conditions:
• Vehicle parked on level ground (refer to
TM 9-2350-287-10).
• Commanders access door removed (para 15-47).
• Machine gun support assembly removed
(para 15-50).
a.
1.
2.
3.
4.
5.
6.
REMOVAL
NOTE
Quantity of washers will vary
according to adjustment setting.
Remove nut (5), washer (4), rubber
bumper (1), and washers (2) from
bumper bracket (3).
Remove quick-disconnect pin (12)
from bracket (15).
Remove connecting link (11) and
separate quick-disconnect pin (12)
from chain (13).
Bend apart S-hook (14) and separate
chain (13) from bracket (15).
Remove two cotter pins (10) from
latch pin (7). Discard cotter pins.
Remove two washers (9), latch pin
(7), latch spring (6), two spacers (8),
and latch (16) from commander’s
cupola body (17) and bracket (15).
15-111
|
