|
| |
TM 9-2350-287-20-2
15-34. LOWER REAR DOOR REPAIR (continued).
e.
INSTALLATION
1.
Install required number of shims (1 ) and handle striker (2) on hull with two new lockwashers (3) and scre ws (4).
WARNING
Adhesives can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive gets on skin or clothing, wash immediately with soap
and
water.
CAUTION
Adhesive coating should not exceed 1/4 inch (6 mm). Excessive amounts of
adhesive will cause seal lip to adhere to seal channel outer wall, destroying seal's
effectiveness.
NOTE
·To seal correctly, upper lip of bottom seal must face lower rear door edge.
·To obtain maximum sealing results, avoid stretching or bunching new seals
during installation.
2.
Apply thin coating of adhesive to mounting surfaces of upper and bottom seals (5 and 10) and channels in lower
rear door (15). Allow adhesive to dry until tacky.
3.
Install bottom seal (10) in channel in lower rear door (15), with lip of seal facing edge of door.
4.
Install outer door handle (16) and sleeve bearing (17) on lower rear door (15).
5.
Install washer (7) and inner door handle (6) on outer door handle (16).
6.
Install slotted nut (9) on outer door handle (16).
7.
Tighten slotted nut (9) until outer door handle (16) can be turned freely, with no excess movement in or out.
8.
Loosen slotted nut (9) until slots in slotted nut (13) align with hole in outer door handle (16).
9.
Install new cotter pin (8) through slotted nut (9) and outer door handle (16).
10.
Apply a bead of adhesive 1/2 inch high and 1/2 inch wide connecting upper seal (5) to bottom seal (10 ). Allow
adhesive to cure for one hour with lower rear door (15) open; then close upper rear door (refer to TM 9-2350-293-
10) and door (15) for about 24 hours until adhesive hardens.
Change 1 15-86
|
