|
| |
TM 9-2350-287-20-2
15-30. CANISTER AND PERSONNEL SIDE DOORWAY SEALS REPLACEMENT
(continued).
b.
1.
2.
3.
4.
5.
6.
7.
INSTALLATION
WARNING
Adhesives can bum easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive gets on skin or clothing, wash immediately with soap and
water.
Apply adhesive to mounting surfaces of channel (3), new shim (l), and new seal (2). Allow adhesive to dry
until tacky.
NOTE
For best results, do not stretch or bunch shim or seal during installation.
Press shim (1) into channel (3), working from one end of shim (1) at bottom center of doorframe. Work around
door frame until ends of shim (1) meet. If necessary, trim ends of shim (1) to obtain smooth fit.
WARNING
Adhesives can bum easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive gets on skin or clothing, wash immediately with soap and
water.
Apply adhesive to front face of shim (l), and allow adhesive to dry until tacky.
Install seal (2) on shim (1), with rounded side of seal (2) facing out. Start at bottom center of door frame and
work around door frame until seal (2) is installed.
Press seal (2) into firm contact with shim (1). Start at top center of seal (2) and work down both sides at once.
WARNING
Drycleaning solvent P-D-880 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat
Wipe seal (2) with drycleaning solvent and rag to remove any adhesive from rounded edge of seal (2).
Close canister door or personnel side door (refer to TM 9-2350-287-10). Allow adhesive on shim and seal
(1 and 2) to cure for 30 minutes with door closed.
15-70
|
