|
| |
TM 9-2350-287-20-2
15-27. PERSONNEL SIDE DOOR REPLACEMENT (continued).
d.
ASSEMBLY
1.
Install two hinges (5) on personnel side door (9) with six screws (8) and new Iockwashers (7).
2.
Install striker (12) on personnel side door (9) with two screws (10) and new Iockwashers (11).
3.
Install bracket (14) and shims (13) on personnel side door (9) with four screws (17), new Iockwashers (16),
and washers (15).
e.
INSTALLATION
Personnel side door is very heavy. At least two persons are required to support door
during installation.
Failure to follow this warning may result in severe injury to
personnel.
NOTE
Two assistants are required to support personnel side door during installation.
1.
While two persons support personnel
side door (9), install shims (4) and
personnel side door (9) on hull with six
screws (6), washers (3), new
Iockwashers (2), and nuts (1).
2.
Close personnel side door (9) (refer to
TM 9-2350-287-10). If door does not
close or binds while closing, loosen
six nuts (1) and screws (6). Have two
assistants raise or lower personnel
side door (9) as necessary until
personnel side door (9) closes without
binding; then tighten six nuts (1).
3.
Open and secure personnel side door
(9) (refer to TM 9-2350-287-10). If
striker (12) does not hold personnel
side door (9) open, loosen two screws
(10) and move striker (12) until it
properly holds open personnel side
door (9); then tighten two screws (10).
FOLLOW-ON MAINTENANCE:
• Close personnel side door (refer to TM 9-2350-287-10).
15-64
|
