|
| |
TM 9-2350-287-20-2
15-20. TOP LEFT DOOR HOLD-OPEN ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Iitial Setup:
Tools/Test Equipment:
Equipment Conditions:
• General mechanic’s tool kit (Item 24,
• Vehicle parked on Ievel ground
Appendix 1)
(refer to TM 9-2350-287-10).
• Top middle door opened (refer to
Materials/Parts:
TM 9-2350-287-10).
• LockWasher (Item 196, Appendix H)
• Self-locking nut (Item 323, Appendix H)
a.
1.
2.
3.
4.
5.
b.
1.
2.
3.
4.
5.
REMOVAL
Remove quick-release pin (6) from bar (9).
Remove screw (4), Iockwasher (3), and S-hook (2), with chain (5) and quick-release pin (6) attached, from
support (1). Discard Iockwasher.
Remove screw (7), washer (8), and bar (9) from support (1).
Remove screw (11), self-locking nut (13), two washers (10), and bar (9) from bracket (12). Discard self-locking
nut.
NOTE
Perform step 5 only if replacing quick-release pin and chain or S-hook.
Unbend S-hook (2), and remove S-hook (2) from chain (5) and quick-release pin (6).
INSTALLATION
NOTE
Perform step 1 only if quick-release pin and chain or S-hook was replaced.
Install S-hook (2) on chain (5) and quick-release pin (6). Bend S-hook (2) to secure to chain (5).
Install bar (9) on bracket (12) with screw (11), two washers (10), and new self-locking nut (13).
Install bar (9) on support (1) with screw (7) and washer (8).
Install S-hook (2), with chain (5) and quick-release pin (6) attached, on support (1) with screw (4) and new
Iockwasher (3).
Install quick-release pin (6) in bar (9).
15-42
|
