|
| |
15-9. EXHAUST DEFLECTORS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment
• Preformed packing (Item 237, Appendix H)
• General mechanic’s tool kit (Item 24,
Appendix I)
Equipment Conditions:
• Vehicle parked on level ground (refer to
Materials/Parts:
TM 9-2350-287-10).
• Preformed packing (Item 236, Appendix H)
a.
REMOVAL
1.
Remove four screws (2), engine exhaust deflector (3), packing (4), and seal support (5) from exhaust opening
on exhaust deck (6). Discard packing.
2.
Remove two screws (1) and washers (10), personnel heater exhaust deflector (9), preformed packing (8), and
spring washer (7) from exhaust opening on exhaust deck (6). Discard preformed packing.
b.
INSTALLATION
1.
Position new preformed packing (8) and spring
washer (7) over exhaust opening in exhaust
deck (6).
NOTE
Make sure opening
in exhaust deflector
points outboard.
2.
Secure personnel heater exhaust deflector
(9) on exhaust deck (6) with two washers
and screws (1).
3.
Install seal support (5) and new packing (4) in
exhaust opening on exhaust deck (6).
4.
Secure engine exhaust deflector (3) to
exhaust deck (6) with four screws (2).
FOLLOW-ON MAINTENANCE:
•None
15-19
TM 9-2350-287-20-2
|
