TM 9-2350-285-24P53.EXPLANATION OF COLUMNS (SECTIONS II AND III) (Con't).(5)Part numbers for bulk materiels are referenced in this column in the line item entry for theitem to be manufactured/fabricated.(6)When the item is not used with all serial numbers of the same model, the effective serialnumbers are shown on the last line(s) of the description (before UOC).(7)The Usable On Code, when applicable (see paragraph 5, Special Information).(8)In the Special Tools List section, the Basis of Issue (BOI) appears as the last line(s) in theentry for each special tool, special TMDE, and other special support equipment. When density of equipments sup-ported exceeds density spread indicated in the Basis of Issue, the total authorization is increased proportionately.(9)The statement “END OF FIGURE” appears just below the last item description in Column 6for a given figure in both Section II and Section III.g.QTY-Column(7).The QTY (quantity per figure) column indicates the quantity of the item used inthe breakout shown on the illustration/figure, which is prepared for a functional group, subfunctional group, groupor an assembly. A “V” appearing in this column in lieu of a quantity indicates that the quantity is variable and thequantity may vary from application to application.4.EXPLANATION OF COLUMNS (SECTION IV).a.NationalStockNumber(NSN)Index.(1)STOCK NUMBER Column.This column lists the NSN by National Item Identification Num-ber (NIIN) sequence. The NIIN consists of the last nine digits of the NSN (i.e., NSN 5305-01-674-1467). Whenusing this column to locate an item, ignore the first four digits of the NSN. However, the complete NSN should beused when ordering items by stock number.(2)FIG. Column. This column lists the number of the figure where the item is identified/located. The figures are in numerical order in Section II and Section III.(3)ITEM Column. The item number identifies the item associated with the figure listed in theadjacent FIG. column. This item is also identified by the NSN listed on the same line.b.PartNumberIndex.Part numbers in this index are listed by part number in ascending alphanu-meric sequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit ofeach group in order A through Z, followed by the numbers 0 through 9 and each following letter or digit in likeorder).(1)CAGEC Column.The Commercial and Government Entity (CAGE) Code (C) is a five-digitalphanumeric code used to identify the manufacturer, distributor, or Government agency, etc., that supplies theitem.(2)PART NUMBER Column.Indicates the primary number used by the manufacturer (indi-vidual, firm, corporation, or Government activity) which controls the design and characteristics of the item bymeans of its engineering drawings, specifications, standards, and inspection requirements to identify an item orrange of items.(3)STOCK NUMBER Column. This column lists the NSN for the associated part number andmanufacturer identified in the PART NUMBER and CAGEC columns to the left.(4)FIG. Column.This column lists the number of the figure where the item is identified/located in Section II and Section III.(5)ITEM Column.The item number assigned to the item as it appears in the figure referencedin the FIG. column.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
