INSTALLATION - TM-9-2350-277-34

INSTALLATION-cont. - TM-9-2350-277-34_598

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
509

TM 9-2350-277-34 INSTALL COMMANDER’S CUPOLA ARMOR SHIELDS (M113A3 AND M1064A3 ONLY) 0088 00 THIS WORK PACKAGE COVERS: Installation (page 0088 00-1). INITIAL SETUP: Maintenance Level Direct Support Tools and Special Tools General Mechanic’s Tool Kit (WP 0120 00, Item 62) Portable Electric Drill (WP 0120 00, Item 7) Portable Electric Drill (WP 0120 00, Item 8) Twist Drill Set (WP 0120 00, Item 10) Twist Drill (WP 0120 00, Item 11) Screw Threading Set (WP 0120 00, Item 58) Materials/Parts Enamel (WP 0122 00, Item 12) Primer Coating (WP 0122 00, Item 24) Shield Kit P/N 11660854 Spacer, 1/16 to 1/8 inch thick (2) Wood blocks of equal height (2) Personnel Required Track Vehicle Repairer 63H10 Helper (H) References See your -10 TB 43-0209 TM 43-0139 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) INSTALLATION 1. If four shield mounting holes are already drilled in cupola hatch, remove and discard four 1/2-13 screws and flat washers from hatch. If mounting holes are NOT drilled, follow Steps 3 - 5. 2. Remove two 5/8-18 screws (1) and washers (2) from outboard support legs of machine gun pintle (3). Discard screws. Keep flat washers. 3. Remove machine gun mount and support from cupola. Close cupola (see your -10). NOTE All dimensions are in inches with metric equivalents. 4. Measure and mark four points (A, B, C, and D) on cupola shown at right. Measure point positions from four existing screw holes that secure machine gun support to cupola. 0088 00-1

Privacy Statement
Press Release
Contact