TM 9-2350-277-34
REPAIR MULTIPIN CONNECTORS
0026 00
THIS WORK PACKAGE COVERS:
Receptacle removal (page 0026 00-1).
Receptacle installation (page 0026 00-2).
Cable connector removal (page 0026 00-2).
Cable connector installation (page 0026 00-3).
INITIAL SETUP:
Maintenance Level
Direct Support
Tools and Special Tools
Automotive Fuel and Electrical System Repair Tool Kit
(WP 0120 00, Item 59)
Electrical Connector Tool Kit (WP 0120 00, Item 60)
Digital Multimeter (WP 0120 00, Item 38)
Soldering Gun (WP 0120 00, Item 54)
Materials/Parts
Insulation tape (WP 0122 00, Item 19)
Tin alloy solder (WP 0122 00, Item 33)
Contacts (AR)
Personnel Required
Fuel and Elec Sys Rep 63G10
Equipment Condition
Repairable parts on workbench
REMOVAL
REMOVE RECEPTACLE
NOTE
Use same procedure for repairing single or multiple lead, and male or female receptacle.
1.
Loosen nut (1) from receptacle (2). Slide nut back on leads (3).
2.
Remove grommet (4) with contacts (5) from rear of receptacle (2).
3.
Push leads (3) into grommet (4) until contacts (5) are fully exposed on other side of grommet. Clip or desolder leads
from contacts. Discard contacts.
4.
Remove grommet (4) and nut (1) from leads (3).
0026 00-1
