INSTALLATION - TM-9-2350-277-20-6

REPAIR CABLE ASSEMBLY (W4/W6) (M1068A3 ONLY)

TM-9-2350-277-20-6 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
94

TM 9-2350-277-20-6 REPLACE INVERTER DC CABLE (W6) (M1068A3 ONLY) — Continued 0840 00 INSTALLATION 1. Install harness W6 in carrier. Route leads behind inverter housing A2 (1) to front face plate (2). 2. Connect harness W6 terminal E1 (3) to ground post G3 (4). Use screw (5) and new lockwasher (6). Make sure there are two leads connected to ground post G3. 3. Connect harness W6 terminal E2 (7) to terminal block TB1 (8) on inverter housing faceplate (2). 4. Attach face plate (2) to front of inverter housing A2 (1) using 10 screws (9) and new lockwashers (10). 5. Connect cable W6 plug (11) to power control box A1 jack J26 (12). FOLLOW-THROUGH STEPS 1. Connect battery ground lead (WP 0338 00). 2. Turn MASTER SWITCH to ON (see your -10). Check that electrical system works properly. 3. Turn MASTER SWITCH to OFF (see your -10). END OF TASK 0840 00-3/4 blank

Privacy Statement
Press Release
Contact