INSTALLATION - TM-9-2350-277-20-5

REPLACE COOLANT HEATER FUEL INLET HOSE AND FITTINGS

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
293

TM 9-2350-277-20-5 REPLACE COOLANT HEATER FUEL PUMP HOSE — Continued 0711 00 INSTALLATION 1. Install adapter (6) on fuel pump (7). 2. Route hose (4) through hull openings. 3. Install seven clamps (3) on hose (4). 4. Connect hose (4) to adapter (6) on fuel pump (7) and elbow (5). 5. Align clamps (3) with hull weldnuts. Secure with seven screws (1) and washers (2). FOLLOW-THROUGH STEPS 1. Open heater fuel shutoff valve (see your -10). 2. Start coolant heater (see your -10). Check for fuel leaks. Turn heater off. 3. Bleed fuel lines (WP 0679 00). 4. Install floor plates (WP 0539 00), (WP 0540 00), (WP 0541 00), (WP 0542 00), (WP 0543 00), (WP 0544 00), or (WP 0545 00). 5. Install personnel heater duct (WP 0706 00). 6. Start engine (see your -10). 7. Raise and lock ramp (see your -10). 8. Stop engine (see your -10). END OF TASK 0711 00-2

Privacy Statement
Press Release
Contact