TM 9-2350-277-20-5REPLACE DATAPLATES, STENCILS, MARKERS, AND DECALS — Continued 0654 00INSTALLATION1. Place old dataplate on hull so that holes in plate do NOT align with holes in hull. Using old dataplate as a template, drillfour new holes.2. Align new dataplate (1) with four new holes. Secure dataplate to hull with four new drive screws (2).NOTEIf carrier identification plate is being replaced, make sure replacement dataplate contains datathat belongs to specific carrier.3. Check applicable stencil chart (see Table of Contents) for location of stencil, and paint new stencil TM 43-0139.4. Check applicable decal and marker chart (see Table of Contents) for location of decal or marker (3). Remove backingfrom decal or marker and press on surface.END OF TASK0654 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
