TM 9-2350-277-20-4
REPLACE OIL CAN BRACKET
0574 00
THIS WORK PACKAGE COVERS:
Removal (page 0574 00-1).
Installation (page 0574 00-1).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Torque Wrench (WP 0926 00, Item 84)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Trim vane lowered (see your -10)
Power plant access door open (see your -10)
REMOVAL
1.
Remove two screws (1), washers (2), and oil can bracket (3) from power plant compartment.
INSTALLATION
1.
Align oil can bracket (3) with bulkhead in power plant compartment. Secure with two washers (2) and screws (1).
TIGHTEN SCREWS TO 22-24 LB-FT (30-33 N m) TORQUE.
FOLLOW-THROUGH STEPS
1.
Close power plant access door (see your -10).
2.
Raise trim vane (see your -10).
END OF TASK
0574 00-1/2 blank
