TM 9-2350-277-20-4
REPAIR DRIVER’S SEAT POST ASSEMBLY — Continued
0557 00
10. Install support (13) on adjuster (3). Secure with four screws (14), washers (15), and new locknuts (16).
11. Install two screws (17) into inboard holes and install plate (18) to post (19) with two screws (17), washers (20), and new
locknuts (21). Tighten locknuts two turns only at this time.
12. Place spacers (22) between post (19) and plate (18) at the outboard holes. Install two screws (17) through spacers and
plate. Secure with two washers (20) and new locknuts (21).
CAUTION
Take care not to tighten the locknuts too tight or the plate will bend.
13. Tighten two locknuts (21), installed in Step 11 above, just enough to bottom against plate (18).
0557 00-5
