TM 9-2350-277-20-3
REPLACE PROPELLER SHAFT AND UNIVERSAL JOINTS — Continued
0405 00
INSTALLATION
NOTE
After installation of one propeller shaft, transmission will not rotate. A helper is required (with
tanker bar) to move carrier to align holes of universal joint with yoke for installation of
propeller shaft on the other side.
NOTE
If not replacing permanently lubricated universal joints, install two lube fittings in each
universal joint.
NOTE
Screws and washers must be clean, dry, and free of lubricant and paint. Washers must be 5/32
inch (4 mm) hardened flat steel only.
1.
Install yoke (1) in final drive (2).
NOTE
When using torque wrench with torque wrench adapter, torque value must be corrected. See
(WP 0155 00) for procedure for converting torque value.
2.
Position propeller shaft (3) in vise and install universal joints (4) with eight new screws (5) and new washers (6).
TIGHTEN SCREWS TO 86-94 LB-FT (117-127 N m) TORQUE. LOOSEN SCREWS, THEN TIGHTEN AGAIN TO
86-94 LB-FT (117-127 N m) TORQUE.
3.
Position propeller shaft (3) with universal joints and secure to transmission and final drive (2) with eight new screws (7)
and new washers (8). TIGHTEN SCREWS TO 86-94 LB-FT (117-127 N m) TORQUE. LOOSEN SCREWS, THEN
TIGHTEN AGAIN TO 86-94 LB-FT (117-127 N m) TORQUE.
0405 00-3
