INSTALLATION (cont) - TM-9-2350-277-20-3

INSTALLATION (cont) - TM-9-2350-277-20-3_636

REPLACE SMOKE GRENADE LAUNCHER WIRING HARNESS (M113A3, M901A3, M981A3, M1059A3, AND M58 ONLY)

TM-9-2350-277-20-3 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
547

TM 9-2350-277-20-3 REPLACE REAR MAIN WIRING HARNESS (M1068A3 ONLY) — Continued 0365 00 75. Connect circuit 37A lead (1) to right utility outlet lead (2). 76. If NBC unit is installed, connect circuit 415 lead (3) to NBC unit switch. 77. Connect circuit 23 lead (4) and circuit 24 lead (5) to right tail light (6). 78. Install four clamps (7) on circuit 29 lead (8). Secure ground lead (9) and clamps on three weldnuts (10) with two new lockwashers (11), three screws (12), and flat washers (13). 79. Install ground lead (9) on right fuel quantity sending unit (14). Secure with screw (15), new lockwasher (16), and new lockwire (17). 80. Connect circuit 29 lead (8) on right fuel quantity sending unit (14). FOLLOW-THROUGH STEPS 1. Install rear floor plate (WP 0544 00). 2. Connect battery ground lead (WP 0338 00). 3. Install battery access cover (see your -10). 4. Turn MASTER SWITCH to ON (see your -10). Check that electrical system works properly. 5. Start engine (see your -10). 6. Raise and lock ramp (see your -10). 7. Stop engine (see your -10). END OF TASK 0365 00-33/34 blank

Privacy Statement
Press Release
Contact