TM 9-2350-277-20-3REPLACE REAR MAIN WIRING HARNESS (M1064A3 ONLY) — Continued 0364 0055. Insert harness (1) through hole in rear plate (2).56. Install harness guard (3) on top of rear hull. Secure with screw (4), washer (5), and new lockwasher (6).57. Route harness (1) along top of right fuel tank (7) and install harness bracket (8) over harness (1). Secure with two screws(9), washers (10), and new lockwashers (11).58. Connect circuit 31 lead (12) to fuel transmitter lead (13) on right fuel tank (7).59. Connect circuit 23 (14) and 24 (15) leads to right tail light leads (16)(17).60. Install harness guard (18) over harness (1) on right fuel tank (7). Secure with two screws (19), washers (20), and newlockwashers (21).FOLLOW-THROUGH STEPS1. Install rear bilge pump strainer (WP 0635 00).2. Install rear floor plate (WP 0543 00).3. Connect battery ground strap (WP 0337 00).4. Turn MASTER SWITCH to ON and start engine (see your -10).5. Check that electrical system works properly (see your -10).6. Raise and lock ramp (see your -10).7. Stop engine (see your -10).END OF TASK0364 00-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business