REPLACE REAR MAIN WIRING HARNESS (M577A3 ONLY)

INSTALLATION (cont) - TM-9-2350-277-20-3_550

TM-9-2350-277-20-3 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
461

TM 9-2350-277-20-3 REPLACE REAR MAIN WIRING HARNESS (M577A3 ONLY) 0363 00 THIS WORK PACKAGE COVERS: Removal (page 0363 00-1). Inspection and Repair (page 0363 00-15). Installation (page 0363 00-15). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Nonelectrical wire (WP 0928 00, Item 42) Gasket Grommet (10) Locknut (8) Lockwasher (59) Personnel Required Unit Mechanic References See your -10 TM 11-7010-256-12&P Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery access cover removed (see your -10) Battery ground lead disconnected (WP 0338 00) Rear floor plate removed (WP 0539 00) REMOVAL 1. Disconnect circuit 29 lead (1) from right fuel quantity sending unit (2). 2. Remove lockwire (3), screw (4), lockwasher (5), and ground lead (6) from sending unit (2). Discard lockwire and lockwasher. 3. Remove three screws (7), two lockwashers (8), flat washer (9), ground lead (6), and three clamps (10), from three weldnuts (11). Remove clamps (10) from circuit 29 lead (1). Discard lockwashers. 4. Disconnect circuit 23 lead (12) and circuit 24 lead (13) from right tail light (14). 5. If NBC unit is installed, disconnect circuit 415 lead (15) from NBC unit switch. 0363 00-1

Privacy Statement
Press Release
Contact