TM 9-2350-277-20-3
REPLACE REAR MAIN WIRING HARNESS (M113A3, M901A3, M981A3, M1059A3, AND
M58 ) Continued
0362 00
NOTE
The M58 does not use connector on wiring harness in hull opening. On M58, route leads
through opening in hull. Apply adhesive sealant around harness, filling opening to a depth of
0.5 to 1.5 inches (1.27 to 3.81 cm).
23. Route circuit 21 (12), 22 (13), 24 (14), and 30 (15) leads through connector (16) and out of carrier. Install connector on
rear top of hull. (All except M58.)
NOTE
The M58 does not use connector, bushing, and hardware only adhesive sealant on wiring
harness in hull opening.
24. Install rubber bushing (17) into connector (16). Secure bushing and leads in connector with nut (18) and washer (19).
(All except M58.)
0362 00-26