TM 9-2350-277-20-2
REPLACE HOSES FROM THERMOSTAT TO VARIABLE SPEED DRIVE
0250 00
THIS WORK PACKAGE COVERS:
Removal (page 0250 00-1).
Installation (page 0250 00-4).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Locknut
Packing (2)
Packing (2)
Strap (1)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Power plant rear access panels removed (see your -10)
Power plant rear access panel support removed
(WP 0439 00)
Ventilating fan drive belt removed (WP 0243 00)
REMOVAL
1.
Remove strap (1) securing hoses (2) and (3) from variable speed drive (4). Discard strap.
NOTE
Install covers on disconnected hydraulic lines, tubes, valves and components during
maintenance. Use tape, cloth, cardboard, or any appropriate material to prevent damage to
compontents or accidental hydraulic fluid spills.
2.
Remove lube port hose (2) from elbow (5) on variable speed drive (4).
0250 00-1
