REPLACE VENTILATING FAN DRIVE PULLEY

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
565

TM 9-2350-277-20-2 REPLACE VENTILATING FAN DRIVE PULLEY 0244 00 THIS WORK PACKAGE COVERS: Removal (page 0244 00-1). Installation (page 0244 00-1). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Mechanical Puller (WP 0926 00, Item 38) Torque Wrench (WP 0926 00, Item 80) Materials/Parts Key Locknut Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Power plant grill raised (WP 0464 00) REMOVAL 1. Remove locknut (1) and washer (2) from shaft of drive pulley (3). Discard locknut. 2. Remove pulley (3) and key (4) from shaft. Discard key. Use mechanical puller. INSTALLATION 1. Install new key (4) in groove on fan drive shaft. Place pulley (3) on shaft and align groove in pulley with key on shaft. Tap pulley on shaft until pulley is seated on shaft. 2. Install washer (2) and new locknut (1) on shaft. TIGHTEN LOCKNUT TO 75-81 LB-FT (102-111 N M) TORQUE. FOLLOW-THROUGH STEPS 1. Lower power plant grill (WP 0464 00). 2. Adjust ventilating fan drive belt (WP 0242 00). END OF TASK 0244 00-1/2 blank

Privacy Statement
Press Release
Contact